3D Printed
These 3D printed split cups have been designed by ourselves and incorporate a handle for easier pouring. They make pouring multiple colours of resin (or paint) at the same time a lot easier.
Note: The residual resin isn't removable, but the cup can be re-used multiple times by letting the resin set then just reuse, no messing about cleaning, we are getting over 30 uses per cup before they need replacing. The prices vary depending on how much filament is required and how long it takes to print them. ml per cavity are measured to the brim of the cup.
The large cups are 115mm Diameter (excluding handle) x 120mm High
2 cavity Purple - 455ml per cavity
3 cavity Pink - 295ml per cavity
4 cavity Green - 210ml per cavity
5 cavity Red - 175ml per cavity
6 cavity Yellow - 145 ml per cavity
Please don’t order more than is showing in stock as once they’re gone they’re gone!.
Note: The residual resin isn't removable, but the cup can be re-used multiple times by letting the resin set then just reuse, no messing about cleaning, we are getting over 30 uses per cup before they need replacing. The prices vary depending on how much filament is required and how long it takes to print them. ml per cavity are measured to the brim of the cup.
The large cups are 115mm Diameter (excluding handle) x 120mm High
2 cavity Purple - 455ml per cavity
3 cavity Pink - 295ml per cavity
4 cavity Green - 210ml per cavity
5 cavity Red - 175ml per cavity
6 cavity Yellow - 145 ml per cavity
Please don’t order more than is showing in stock as once they’re gone they’re gone!.
